SROS Command Line Interface Reference Guide
Enable Mode Command Set
show ip urlfilter
Use the show ip urlfilter command to display configured URL filter and server information.
Syntax Description
No subcommands.
Default Values
No default necessary for this command.
Usage Examples
The following example shows sample output from the show ip urlfilter command:
ProCurve>enable
ProCurve#show ip urlfilter
Configured for Websense URL filtering.
Filters
-------
Name: "filter1"
Ports: HTTP(80)
Interfaces that filter is applied to:
eth 0/2 inbound
Servers
-------
IP address: 10.100.23.116
Port: 15868
Timeout: 5
Excluded domains
----------------
Permit www.procurve.com
Other Settings
--------------
Allow mode: Off
Maximum outstanding requests: 500
Maximum number of response packets buffered: 100
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
242