HP ProCurve 7102dl Reference Manual page 906

SROS Command Line Interface Reference Guide
backup call-mode <role>
Use the backup call-mode command to specify whether the configured backup interfaces answers or
originates (or a combination of both) backup calls. Use the no form of this command to return to the
default value.
Syntax Description
<role>
answer
answer-always
originate
originate-answer
originate-answer-always
Default Values
By default, the backup call-mode is set to originate-answer.
Functional Notes
The majority of the configuration for the SROS backup implementation is configured via the backup PPP
interface configuration commands. However, the numbers dialed are configured in the primary interface.
Full sample configurations follow:
Sample config for remote router (dialing out)
hostname "Remote7203dl"
enable password password
!
interface eth 0/1
ip address 192.168.1.254 255.255.255.0
no shutdown
!
interface modem 1/3
no shutdown
!
interface t1 1/1
coding b8zs
framing esf
clock source line
tdm-group 1 timeslots 1-24
no shutdown
!
5991-2114
Selects the role the router will take in backup of this sub-interface.
Answers and backs up primary link on failure.
Answers and backs up regardless of primary link state.
Originates backup call on primary link failure.
Originates or answers call on primary link failure.
Originates on failure; answers and backs up always.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
904