Modem Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
M I
ODEM NTERFACE
To activate the Modem Interface Configuration mode, enter the interface modem command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface modem 1/2
ProCurve(config-modem 1/2)#
Note
The modem interface number in the example above is shown as modem 1/2. This number is
based on the interface's location (slot/port) and could vary depending on the unit's
configuration. Use the do show interfaces command to determine the appropriate interface
number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
caller-id override [always <number> | if-no-cid <number>]
dialin on page 696
init-string <string>
resource pool-member <pool-name> [<cost>]
5991-2114
C
ONFIGURATION
on page 1434
on page 697
© Copyright 2006 Hewlett-Packard Development Company, L.P.

Modem Interface Configuration Command Set

C
OMMAND
on page 695
on page 698
S
ET
694