HP ProCurve 7102dl Reference Manual page 383

SROS Command Line Interface Reference Guide
ip as-path-list <listname>
Use the ip as-path-list command to create IP autonomous system (AS) path lists for route-map use. Use
the no form of this command to delete the AS path list.
Syntax Description
<listname>
Default Values
By default, no as-path lists are defined.
Functional Notes
AS path lists are a type of route filter that permits or denies BGP routes based on the AS_PATH attribute.
AS path lists define a list of AS specifications (to permit or deny traffic) which can then be referenced in a
route map. See the Usage Examples section below.
Usage Examples
The following example creates the AS path list list5 and enters the IP as-path-list command mode:
ProCurve(config)#ip as-path-list list5
ProCurve(config-as-path-list)#
5991-2114
Specifies the name of the AS-path list. See
1271 for more information on the available options.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
AS Path List Command Set
on page
381