SROS Command Line Interface Reference Guide
Ethernet Interface Configuration Command Set
arp arpa
Use the arp arpa command to enable address resolution protocol (ARP) on the Ethernet interface.
Syntax Description
arpa
Sets standard address resolution protocol for this interface.
Default Values
The default for this command is arpa.
Usage Examples
The following example enables standard ARP for the Ethernet interface:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#arp arpa
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
620