HP ProCurve 7102dl Reference Manual page 369

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
ProCurve(config-fr 7.22)#frame-relay interface-dlci 30
ProCurve(config-fr 7.22)#ip address 10.44.69.1 255.255.255.252
ProCurve(config-fr 7.22)#no shutdown
Step 3: (VALID ONLY FOR T1 INTERFACES)
Specify the group of DS0s used for signaling on the T1 interface by creating a tdm-group. Group any
number of aggregate DS0s together to create a data pipe for layer 2 signaling. Also use the tdm-group
command to specify the per-DS0 signaling rate on the interface. For example, the following creates a
tdm-group labeled 9 containing 20 DS0s (each DS0 having a data rate of 56 kbps).
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#tdm-group 9 timeslots 1-20 speed 56
ProCurve(config-t1 1/1)#exit
Step 4:
Make the association between the layer 2 endpoint and the physical interface using the bind command.
For example, the following creates a bind (labeled 5) to make an association between the Frame Relay
virtual interface (fr 7) and the tdm-group configured on interface t1 1/1 (tdm-group 9).
ProCurve(config)#bind 5 t1 1/1 9 fr 7
Usage Examples
The following example creates a Frame Relay virtual interface (labeled 1) and enters the Frame Relay
Interface Configuration mode:
ProCurve(config)#interface fr 1
ProCurve(config-fr 1)#
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 367