HP ProCurve 7102dl Reference Manual page 779

SROS Command Line Interface Reference Guide
oam retry <up-count> <down-count> <retry-frequency>
Use the oam retry command to
Maintenance (OAM) management for an ATM interface. Use the no form of this command to
disable OAM management parameters.
Syntax Description
>
<up-count>
<down-count>
<retry-frequency>
Default Values
By default, the up-count is set to 3, the down-count is set to 5, and the retry frequency is 1.
Usage Examples
The following example configures the OAM parameters with an up-count of 2, down-count of 2, and retry
frequency of 10:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#oam retry 2 2 10
5991-2114
configure parameters related to Operation, Administration, and
Specifies the number of consecutive end-to-end F5 OAM loopback cell responses
that must be received in order to change a PVC connection state to up. The range
is from 1 to 255.
Specifies the number of consecutive end-to-end F5 OAM loopback cell responses
that are not received in order to change a PVC state to down. The range is from
1 to 255.
Specifies the frequency (in seconds) that end-to-end F5 OAM loopback cells are
transmitted when a change in the up/down state of a PVC is being verified. The
range is from 1 to 600.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
777