HP ProCurve 7102dl Reference Manual page 18

SROS Command Line Interface Reference Guide
show snmp
Use the show snmp command to display the system Simple Network Management Protocol (SNMP)
parameters and current status of SNMP communications.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Usage Examples
The following is an example output using the show snmp command for a system with SNMP disabled and the
default chassis and contact parameters:
ProCurve>show snmp
Chassis: Chassis ID
Contact Name:
Contact Phone:
Contact Email:
Contact Pager:
Management URL:
Management URL Label:
0 Rx SNMP packets
0 Bad community names
0 Bad community uses
0 Bad versions
0 Silent drops
0 Proxy drops
0 ASN parse errors
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Basic Mode Command Set
16