HP ProCurve 7102dl Reference Manual page 61

SROS Command Line Interface Reference Guide
clear spanning-tree detected-protocols [interface <interface id>]
Use the clear spanning-tree detected-protocols command to restart the protocol migration process.
Syntax Description
interface
<interface id>
Default Values
No default value necessary for this command.
Functional Notes
The ProCurve Secure Router has the ability to operate using the rapid spanning-tree protocol or the legacy
802.1D version of spanning-tree. When a BPDU (bridge protocol data unit) of the legacy version is
detected on an interface, the ProCurve Secure Router automatically regresses to using the 802.1D
spanning-tree protocol for that interface. Issue the clear spanning-tree detected-protocols command to
return to rapid spanning-tree operation.
Usage Examples
The following example re-initiates the protocol migration process on eth 0/2:
ProCurve>enable
ProCurve#clear spanning-tree detected-protocols interface ethernet 0/2
The following example re-initiates the protocol migration process on all interfaces:
ProCurve>enable
ProCurve#clear spanning-tree detected-protocols
5991-2114
Optional. Choose the Ethernet interface.
Optional. Enter a valid interface ID (e.g., 0/1 for Ethernet 0/1).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
59