HP ProCurve 7102dl Reference Manual page 524

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
spanning-tree edgeport default
Use the spanning-tree edgeport default command to configure all ports to be edgeports by default. Use
the no form of this command to disable the setting.
Syntax Description
No subcommands.
Default Values
Disabled by default.
Usage Examples
The following example configures all interfaces running spanning tree to be edgeports by default:
ProCurve(config)#spanning-tree edgeport default
An individual interface can be configured to not be considered an edgeport. For example:
ProCurve(config)#interface ethernet 0/1
ProCurve(config-eth 0/1)#no spanning-tree edgeport
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 522