HP ProCurve 7102dl Reference Manual page 278

SROS Command Line Interface Reference Guide
show spanning-tree <bridgegroup#> [realtime]
Use the show spanning-tree command to display the status of the spanning-tree protocol.
Syntax Description
<bridgegroup#>
realtime
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the #terminal length command).
Usage Examples
The following is an example output using the show spanning-tree command:
ProCurve>enable
ProCurve#show spanning-tree
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:12:79:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:12:79:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface Role
eth 0/2 Desg
eth 0/3 Desg
eth 0/4 Desg
giga-eth 0/1 Desg
giga-eth 0/2 Desg
5991-2114
Optional. Display spanning-tree for a specific bridge group.
Shows full screen spanning-tree protocol status in real-time.
Sts Cost Prio.Nbr
FWD 19 128.2
FWD 19 128.3
FWD 19 128.4
FWD 4 128.25
FWD 4 128.26
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
Type
P2p
P2p
P2p
P2p
P2p
276