HP ProCurve 7102dl Reference Manual page 294

SROS Command Line Interface Reference Guide
sip check-sync
Use the sip check-sync command to send a check-sync notification to all IP phones registered to the unit.
When an IP phone receives this check-sync notification, the phone will check for possible configuration
changes stored on the server. Variations of this command include:
sip check-sync
sip check-sync firmware-upgrade
Syntax Description
firmware-upgrade
Default Values
No default value necessary for this command.
Usage Examples
The following example notifies all IP phones to check for a change in configuration:
ProCurve>enable
ProCurve#sip check-sync
5991-2114
Optional. Specifies that the check-sync notification will prompt the
phones to update their firmware. Check-sync notifications containing
a phone firmware-upgrade are more time consuming than a generic
check-sync and require a coordination effort when updating all
phones on the network. This command staggers phone notifications
on the network to avoid system congestion.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
292