HP ProCurve 7102dl Reference Manual page 78

SROS Command Line Interface Reference Guide
copy startup-config
Use the copy startup-config command to create a copy of the current startup-configuration and replace the
current running-configuration or save it to a specified memory location (compact flash or system flash).
Variations of this command include:
copy startup-config tftp
copy startup-config xmodem
copy startup-config <filename> cflash <filename>
copy startup-config <filename> flash <filename>
copy startup-config <filename> running-config
Syntax Description
tftp
xmodem
cflash <filename>
flash <filename>
running-config
Default Values
No default value necessary for this command.
Usage Examples
The following example copies the primary startup-configuration file to the current running-configuration:
ProCurve>enable
ProCurve#copy startup-config running-config
Opening and applying file...
Note
Any changes made to the current running configuration of the router that have not been
saved to the startup configuration file (using the write command) will be lost when the copy
startup-config running-config command is entered.
5991-2114
Specifies sending the file using the trivial file transfer protocol (TFTP). After
entering copy startup-config tftp, the SROS prompts for the following
information:
Address of remote host:
Destination filename:
Sends the current startup-configuration file (using the XMODEM protocol) to the
terminal connected to the Console port.
Specifies the destination memory location for the copied file as compact flash
and specifies the filename for the copied file.
Specifies the destination memory location for the copied file as system flash
memory and specifies the filename for the copied file.
Replaces the current running configuration file with the primary
startup-configuration.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Specifies the IP address of the TFTP server.
Specifies the filename to use when storing the copied
file on the TFTP server. (The file will be placed in the
default directory established by the TFTP server.)
Enable Mode Command Set
76