SROS Command Line Interface Reference Guide
Enable Mode Command Set
enable
Use the enable command to enter a password for the Enable mode.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Functional Notes
The Enable Command mode provides access to operating and configuration parameters and should be
password protected to prevent unauthorized use. Use the enable password command (found in the
Global Configuration mode) to specify an Enable Command mode password. If the password is set,
access to the Enable Commands (and all other "privileged" commands) is only granted when the correct
enable password [md5] <password>
password is entered. Refer to
on page 355 for more information.
Usage Examples
The following example enters the Enable Command mode and defines an Enable Command mode
password:
ProCurve>enable
Password: *****
ProCurve#
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
150