HP ProCurve 7102dl Reference Manual page 688

SROS Command Line Interface Reference Guide
et-clock-source [rxclock | txclock]
Use the et-clock-source command to configure the clock source used when creating the external transmit
reference clock (et-clock). Use the no form of this command to return to the default value.
Syntax Description
rxclock
txclock
Default Values
By default, the clock recovered from the transmit signal is used to generate the et-clock.
Functional Notes
The et-clock is an interface timing signal (provided by the DTE device) used to synchronize the transfer of
transmit data.
Usage Examples
The following example configures the serial interface to recover the clock signal from the received signal
and use it to generate et-clock:
ProCurve(config)#interface serial 1/1
ProCurve(config-ser 1/1)#et-clock-source rxclock
5991-2114
Specifies using the clock recovered from the receive signal to generate et-clock.
Specifies using the clock recovered from the transmit signal to generate et-clock.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Serial Interface Configuration Command Set
686