HP ProCurve 7102dl Reference Manual page 929

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
frame-relay interface-dlci <dlci>
Use the frame-relay interface-dlci command to configure the Data Link Connection Identifier (DLCI) for
the Frame Relay sub-interface. This setting should match the DLCI supplied by your Frame Relay service
provider. Use the no form of this command to remove the configured DLCI.
Syntax Description
<dlci> Specifies numeric value supplied by your provider.
Default Values
By default, the DLCI is populated with the sub-interface identifier. For example, if configuring the virtual
Frame Relay sub-interface labeled fr 1.20, the default DLCI is 20.
Usage Examples
The following example configures a DLCI of 72 for this Frame Relay endpoint:
ProCurve(config)#interface frame relay 1.16
ProCurve(config-fr 1.16)#frame-relay interface-dlci 72
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 927