HP ProCurve 7102dl Reference Manual page 619

SROS Command Line Interface Reference Guide
Note
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
ProCurve>enable
Password: xxxxx
ProCurve#config term
ProCurve(config)#int eth 0/1
ProCurve(config-eth 0/1)#?
access-policy
alias
arp
bandwidth
bridge-group
etc....
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
arp arpa on page 620
bandwidth <value>
bridge-group <group#>
bridge-group <group#> vlan-transparent
crypto map <mapname>
dynamic-dns on page 626
encapsulation 802.1q
full-duplex on page 629
5991-2114
- Assign access control policy for this interface
- A text name assigned by an SNMP NMS
- Set ARP commands
- Set bandwidth informational parameter
- Assign the current interface to a bridge group
on page 1434
on page 619
on page 621
on page 622
on page 624
on page 628
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
on page 623
on page 1431
617