HP ProCurve 7102dl Reference Manual page 197

SROS Command Line Interface Reference Guide
show interfaces adsl <slot/port>
Use the show interfaces adsl command to display information related to the ADSL port. Variations of this
command include the following:
show interfaces adsl <slot/port>
show interfaces adsl <slot/port> information
show interfaces adsl <slot/port> information atuc
show interfaces adsl <slot/port> information atur
show interfaces adsl <slot/port> information bit-allocation
show interfaces adsl <slot/port> performance-statistics
show interfaces adsl <slot/port> performance-statistics <x-y>
show interfaces adsl <slot/port> performance-statistics total-24-hour
show interfaces adsl <slot/port> version
Syntax Description
<slot/port>
information
information atuc
information atur
information bit-allocation
performance-statistics
performance-statistics <x-y>
Note
Note: If you want to display the 24th interval, enter (for example) show interface t11/1
performance-statistics 24-24. Entering show interface t1 1/1 performance-statistics 24
results in displaying the 24-hour statistics. Any number other than 24 (between 1 and 96)
results in the correct display of the selected interval (e.g., show interface t1 1/1
performance-statistics 4 shows the fourth interval).
version
Default Values
No default is necessary for this command.
5991-2114
Specifies interface slot and port number.
Optional. Specifies all available information for the ADSL
configuration (atuc, atur, and bit-allocation).
Optional. Shows ADSL interface remote information.
Optional. Shows ADSL local information.
Optional. Shows ADSL DMT bit-allocation table.
Optional. Displays the current 15-minute interval, the current
24-hour totals, and all 96 stored intervals.
Optional. Shows the current 15-minute interval, the current 24-hour
totals, and all intervals from x through y. This command is basically
the same thing as the performance-statistics command with the
added function of allowing you to specify a particular interval (or
range of intervals) to display rather than displaying all
96.performance-statistics total-24-hourOptional. Displays the
current 24-hour totals and the past seven 24-hour intervals.
Optional. Displays current version information (e.g., model and list
number, software version, etc.) for the T1 interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
195