HP ProCurve 7102dl Reference Manual page 409

SROS Command Line Interface Reference Guide
ip firewall fast-nat-fallover
Use the ip firewall fast-nat-fallover command to delete associations on default route policy-class
changes.
Note
The SROS security features must be enabled (using the ip firewall command) for the
stateful inspection firewall to be activated.
Syntax Description
No subcommands.
Default Values
All SROS security features are disabled by default until the ip firewall command is issued at the Global
Configuration prompt. In addition, the fast NAT fallover is disabled until the ip firewall fast-nat-fallover
command is issued.
Usage Examples
The following example enables fast-nat-fallover:
ProCurve(config)#ip firewall fast-nat-fallover
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
407