HP ProCurve 7102dl Reference Manual page 745

SROS Command Line Interface Reference Guide
encapsulation [aal5mux ip | aal5mux ppp | aal5snap]
Use the encapsulation command to configure the encapsulation type for the ATM Adaptation Layer
(AAL) of the ATM Protocol Reference model. Use the no form of this command to return to the default
setting.
Syntax Description
aal5mux ip
aal5mux ppp
aal5snap
Default Values
By default, the encapsulation type is aal5snap.
Functional Notes
For PPP and PPPoE, the encapsulation type can be aal5snap or aal5mux ppp.
For IP with no bridging, the encapsulation type can be aal5snap or aal5mux ip.
For IP with bridging, the encapsulation type can only be aal5snap
For bridging, the encapsulation type can only be aal5snap.
Usage Examples
The following example sets the encapsulation type to all5snap:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#encapsulation aal5snap
5991-2114
Specifies encapsulation type for multiplexed virtual circuits using the IP
protocol.
Specifies encapsulation type for multiplexed virtual circuits using the
Point-to-Point (PPP) protocol.
Specifies encapsulation type that supports LLC/SNAP protocols.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
743