SROS Command Line Interface Reference Guide
caller-id override [always <number> | if-no-cid <number>]
Use the caller-id override command to configure the unit to replace caller ID information with a
user-specified number. Use the no form of this command to disable any caller ID overrides.
Syntax Description
always <number>
if-no-cid <number>
Default Values
By default, this command is disabled.
Functional Notes
Forces a replacement of the incoming caller ID number with the number given. The received caller ID, if
any, is discarded, and the given override number is used to connect the incoming call to a circuit of the
same number.
Usage Examples
The following example configures the unit to always provide the given number as the caller ID number:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#caller-id override always 5551000
5991-2114
Always forces replacement of the incoming caller ID number with the number
given.
Replaces the incoming caller ID number with the number given only if there is no
caller ID information available for the incoming call.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
582