HP ProCurve 7102dl Reference Manual page 192

SROS Command Line Interface Reference Guide
show hosts [verbose]
Use the show hosts command to display information such as the domain name, name lookup service, a list
of name server hosts, and the cached list of host names and addresses on the network to which you can
connect.
Syntax Description
verbose
Default Values
No default value necessary for this command.
Functional Notes
The list below describes the fields contained in the host table:
• Flags: Indicate whether the entry is permanent (P) or temporary (T) and if the entry is OK or expired
(EXP).
• Age: Indicates the age of the entry.
• Type: Shows the protocol type.
• Address: Displays the IP address for the entry.
Usage Examples
The following example is sample output from the show hosts command:
ProCurve>enable
ProCurve#show hosts
Name/address lookup uses domain name service
DNS Proxy is disabled
Default domain is not set
Name servers are 1.1.1.1 2.2.2.2
Host Flags
Example1 (P OK)
Example2 (P OK)
5991-2114
Enables detailed messaging.
Age Type
- - IP
- - IP
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Address
1.1.1.1
2.2.2.2
Enable Mode Command Set
190