HP ProCurve 7102dl Reference Manual page 143

SROS Command Line Interface Reference Guide
debug spanning-tree [config | events | general | topolgy]
Use the debug spanning-tree command to enable the display of spanning-tree debug messages. Debug
messages are displayed (real-time) to the terminal (or Telnet) screen. Use the no form of this command to
disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
config
events
general
topology
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example enables the display of general spanning-tree debug messages:
ProCurve>enable
ProCurve#debug spanning-tree general
5991-2114
Enables the display of spanning-tree debug messages when configuration
changes occur.
Enables the display of debug messages when spanning-tree protocol events
occur.
Enables the display of general spanning-tree debug messages.
Enables the display of debug messages when spanning-tree protocol topology
events occur.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
141