HP ProCurve 7102dl Reference Manual page 762

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
ip pim sparse-mode
Use the ip pim sparse-mode command to enable PIM Sparse Mode on the interface. Use the no form of
this command to disable PIM Sparse Mode.
Syntax Description
No subcommands.
Default Values
By default, PIM Sparse Mode is disabled for all interfaces.
Functional Notes
PIM Sparse Mode is a multicast routing protocol that makes use of the unicast forwarding table.
PIM-systems builds unidirectional shared trees rooted at a Rendezvous Point (RP) for a multicast group or
a shortest-path tree rooted at a specific source for a multicast group.
Usage Examples
The following example enables PIM sparse-mode on the ATM interface 1.1:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip pim sparse-mode
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 760