HP ProCurve 7102dl Reference Manual page 75

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

Enable Mode Command Set

The following example copies the software file J03_01.biz (located in flash memory) to the connected

terminal using XMODEM protocol:

ProCurve>enable

ProCurve#copy flash xmodem

Source filename J03_01.biz

Begin the Xmodem transfer now...

Press CTRL+X twice to cancel

The SROS is now ready to transmit the file on the CONSOLE port (using the XMODEM protocol). The next

step in the process may differ depending on the type of terminal emulation software you are using. For

HyperTerminal, you will now select Transfer > Receive File and select the destination. Once the transfer

is complete, information similar to the following is displayed:

Sent 231424 bytes.

Transfer complete

Chapters

Table of Contents