HP ProCurve 7102dl Reference Manual page 700

SROS Command Line Interface Reference Guide
resource pool-member <pool-name> [<cost>]
Use the resource pool-member command to assign the interface to a resource pool, making it a demand
routing resource. Use the no form of this command to return to the default value.
Syntax Description
<pool-name>
<cost>
Default Values
By default, the interface is not assigned to any resource pool.
Usage Examples
The following example configures an analog modem interface as a member of resource pool MyPool:
ProCurve(config)#interface modem 1/2
ProCurve(config-modem 1/2)#resource pool-member MyPool
5991-2114
Specifies the name of the resource pool to which this interface is assigned.
Optional. Specifies the cost of using this resource interface within the specified
pool. In the event of a tie, a resource with a lower cost will be selected first.
Interfaces with the same cost will be selected in alphabetical order by interface
name.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
Modem Interface Configuration Command Set
698