Bri Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
BRI I
NTERFACE
To activate the BRI Interface Configuration mode, enter the interface bri command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#
Note
The BRI interface number in the example above is shown as bri 1/2. This number is based
on the interface's location (slot/port) and could vary depending on the unit's configuration.
Use the do show interfaces command to determine the appropriate interface number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
bonding commands
caller-id override [always <number> | if-no-cid <number>]
isdn [ldn 1 | ldn 2] <ldn>
isdn [spid 1 | spid 2] <spid string> <LDN>
isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni]
loopback local [all | b1 | b2 | both] on page 586
loopback network [b1 | b2 | both] on page 587
maintenance [reset | restart-d] on page 588
resource pool-member <pool-name> [<priority>] on page 589
test-call [dial <number> | speed <56 | 64> | answer | hangup | hangup channels <1 | 2>] on page 590
5991-2114
C
ONFIGURATION
on page 1434
begin on page 576
on page 583
© Copyright 2007 Hewlett-Packard Development Company, L.P.

BRI Interface Configuration Command set

C
OMMAND SET
on page 582
on page 584
on page 585
on page 1431
575