HP ProCurve 7102dl Reference Manual page 290

SROS Command Line Interface Reference Guide
show udp info [realtime] <session id>
Use the show udp info command to display User Datagram Protocol (UDP) session information.
Syntax Description
realtime
<session id>
Default Values
No default necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the #terminal length command).
Usage Examples
The following example shows sample output from the show udp info command:
ProCurve>enable
ProCurve#show udp info
UDP Session Entries
ID Local Port IP Address
--- --------------- ----------------- -----------
2 520 0.0.0.0
3 0 0.0.0.0
4 161 0.0.0.0
5 8 127.0.0.1
6 10 0.0.0.0
7 6 127.0.0.1
8 4 127.0.0.1
9 14 127.0.0.1
10 12 127.0.0.1
5991-2114
Displays full-screen output in real-time. See the Functional Notes below for more
information.
Specifies ID of session to display (Range: 0 to 31).
Socket
1
4
5
7
11
16
17
18
19
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
288