HP ProCurve 7102dl Reference Manual page 122

SROS Command Line Interface Reference Guide
debug ip pim-sparse register [event | state] <address>
Use the debug ip pim-sparse register command to display protocol-independent multicast (PIM) sparse
source registration messages. Debug messages are displayed (real-time) to the terminal (or Telnet) screen.
Use the no form of this command to disable debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
event
state
<address>
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates all PIM sparse registration state changes:
ProCurve>enable
ProCurve#debug ip pim-sparse register state
5991-2114
Displays PIM sparse register events.
Displays PIM sparse register state changes.
Specifies group address to filter.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
120