SROS Command Line Interface Reference Guide
ip urlfilter <name> [in | out]
Use the ip urlfilter command to apply a URL filter to the interface for all inbound or outbound traffic. Use
the no form of this command to remove the URL filter from an interface.
Syntax Description
<name>
in
out
Default Values
By default, there are no URL filters applied to any interfaces.
Functional Notes
The firewall must be enabled using the ip firewall command in order to use URL filters. The URL filter
must be created by using the ip urlfilter <name> http command before applying it to the interface. Refer
ip urlfilter <name> http
to
Usage Example
The following example performs URL filtering on all traffic entering through BVI interface 1 and matches
the URL filter named MyFilter:
ProCurve(config)#interface bvi 1
ProCurve(config-bvi 1)#ip urlfilter MyFilter in
5991-2114
Specifies the URL filter name to use on the interface.
Applies the filter to the inbound traffic.
Applies the filter to the outbound traffic.
on page 455 for more information on using this command.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BVI Interface Config Command Set
811