HP ProCurve 7102dl Reference Manual page 832

SROS Command Line Interface Reference Guide
demand-hold-queue <packets> timeout <seconds>
Use the demand-hold-queue timeout command to set the number and length of time interesting packets
will be held while a connection is being made. Use the no form of this command to restore the default
values.
Syntax Description
<packets>
<seconds>
Default Values
By default, the hold queue is disabled.
Usage Examples
The following example configures demand interface 1 to hold 50 packets in the queue for up to
120 seconds:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#demand-hold-queue 50 timeout 120
5991-2114
Specifies the number of packets that may be stored in the hold queue. Range is 0
to 100.
Specifies the number of seconds a packet may remain in the hold queue. Range
is 0 to 255 seconds.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
830