HP ProCurve 7102dl Reference Manual page 76

SROS Command Line Interface Reference Guide
copy running-config
Use the copy running-config command to create a copy of the current running-configuration and replace
the current startup-configuration or save it to a specified memory location (compact flash or system flash).
Variations of this command include:
copy running-config tftp
copy running-config xmodem
copy running-config <filename> cflash <filename>
copy running-config <filename> flash <filename>
copy running-config <filename> startup-config
Syntax Description
tftp
xmodem
cflash <filename>
flash <filename>
startup-config
Default Values
No default value necessary for this command.
Usage Examples
The following example copies the current running-configuration file to the startup configuration file located
in flash memory:
ProCurve>enable
ProCurve#copy running-config startup-config
Building configuration...
NONVOL:/startup-config
Done. Success!
5991-2114
Specifies sending the file using the trivial file transfer protocol (TFTP). After
entering copy running-config tftp, the SROS prompts for the following
information:
Address of remote host:
Destination filename:
Sends the current running-configuration file (using the XMODEM protocol) to
the terminal connected to the Console port.
Specifies the destination memory location for the copied file as compact flash
and the destination filename.
Specifies the destination memory location for the copied file as system flash
memory and the destination filename.
Replaces the primary startup-configuration file with the current
running-configuration.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Specifies the IP address of the TFTP server.
Specifies the filename to use when storing the copied
file on the TFTP server. (The file will be placed in the
default directory established by the TFTP server.)
Enable Mode Command Set
74