HP ProCurve 7102dl Reference Manual page 234

SROS Command Line Interface Reference Guide
show ip policy-sessions <policyname> [all]
Use the show ip policy-sessions command to display a list of current policy class associations. See ip
policy-class <policyname> on page 426 for information on configuring access policies.
Syntax Description
<policyname>
all
Default Values
No default value necessary for this command.
Usage Examples
The following is sample output from the show ip policy-sessions command:
ProCurve>enable
ProCurve#show ip policy-sessions
Protocol (TTL) [in crypto map] -> [out crypto map] Destination policy-class
Src IP Address Src Port
-------------------------------------------------------------------------------------------------------------------------------------------
Policy class "Public":
tcp (13)
192.168.1.142 2621
tcp (13)
192.168.1.142 2622
tcp (13)
192.168.1.142 2623
tcp (13)
192.168.1.142 2624
5991-2114
Optional. Displays policy class associations for a specific policy class.
Optional. Displays all policy sessions, including active associations (through
which the firewall is allowed to pass traffic) and associations flagged for
deletion (through which the firewall is forbidden to pass traffic). Associations
flagged for deletion will usually be freed within a few seconds of timeout or
deletion, depending on packet congestion; servicing of packets is given
priority. New traffic matching an association will create a new active
association, provided the traffic still matches a policy-class allow or NAT
entry.
Dest IP Address
192.168.19.2
192.168.19.2
192.168.19.2
192.168.19.2
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
Dst Port NAT IP Address
1 10.10.10.1
2 10.10.10.1
3 10.10.10.1
4 10.10.10.1
NAT Port
3000
3001
3002
3003
232