HP ProCurve 7102dl Reference Manual page 818

SROS Command Line Interface Reference Guide
traffic-shape rate <value> <burst>
Use the traffic-shape rate command to specify and enforce an output bandwidth for the BVI interface.
Use the no form of this command to disable this feature.
Syntax Description
<value>
<burst>
Default Values
By default, traffic-shape rate is disabled.
Functional Notes
Traffic shaping can be used to limit the VLAN interface to a particular rate or to specify use of QoS.
Usage Examples
The following example sets the outbound rate of bvi 1 to 128 kbps and applies a QoS policy that gives all
RTP traffic priority over all other traffic:
ProCurve(config)#qos map voip 1
ProCurve(config-qos-map)#match ip rtp 10000 10500 all
ProCurve(config-qos-map)#priority unlimited
ProCurve(config-qos-map)#interface bvi 1
ProCurve(config-bvi 1)#traffic-shape rate 128000
ProCurve(config-bvi 1)#qos-policy out voip
5991-2114
Specifies the rate (in bits per second) at which the interface should be shaped.
Optional. Specifies the allowed burst in bytes. By default, the burst is specified as
the rate divided by 5 and represents the number of bytes that would flow within
200 ms.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BVI Interface Config Command Set
816