HP ProCurve 7102dl Reference Manual page 203

SROS Command Line Interface Reference Guide
Usage Examples
In the following example, all BGP routes are displayed whose community numbers match those listed in
the show ip bgp community command.
ProCurve>enable
ProCurve#show ip bgp community local-as 10:405
BGP local router ID is 10.22.131.241, local AS is 302.
Status codes: * valid, > best, i - internal, o - local
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
10.22.152.20/30
10.22.152.24/29
10.22.152.36/30
10.22.152.52/30
11.0.0.0/30
12.0.0.0/30
13.0.0.0/30
14.0.0.0/30
20.0.0.0/30
21.0.0.0/30
Total RIB entries = 10
Information displayed includes: the ID of this router and its Autonomous System (AS) number; the
destination Network address of the route learned; the Next Hop address to that network; the Metric; the
Local Preference value (set using the set local-preference command); and the AS Path to the destination
network.
The following is a sample output for the show-ip bgp community command with an exact match specified:
BGP routes with the community numbers specified and only those specified are shown
ProCurve>enable
ProCurve#show ip bgp community 1001 2001 3001 exact
BGP local router ID is 192.168.9.1, local AS is 252.
Status codes: * valid, > best, i - internal, o - local
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
* 192.168.11.0/24
* 192.168.12.0/24
*> 192.168.32.0/24 10.22.27.249
*> 192.168.33.0/24 10.22.27.249
Total RIB entries = 4
5991-2114
Next Hop Metric
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
10.22.131.10 304
NextHop Metric
10.22.27.251
10.22.27.251
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
LocPrf Path
302 300 1 3 4 i
302 300 1 3 4 5 i
302 300 1 3 4 i
302 300 1 3 4 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 5 i
302 300 1 3 4 5 i
LocPrf Path
249 251 i
249 251 i
249 i
249 i
201