HP ProCurve 7102dl Reference Manual page 519

SROS Command Line Interface Reference Guide
sntp retry-timeout <time>
Use the sntp retry-timeout command to set the amount of time to wait for a response before allowing a
new request.
Syntax Description
<time>
Default Values
By default, the retry timeout is set to 5 seconds.
Usage Examples
The following example sets the SNTP retry timeout to 10 seconds:
ProCurve(config)#sntp retry-time 10
5991-2114
Specifies time (in seconds) to wait for a response before retrying. The range is
from 3 to 4,294,967,294.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
517