HP ProCurve 7102dl Reference Manual page 956

SROS Command Line Interface Reference Guide
ip route-cache
Use the ip route-cache command to enable route caching on the interface. Use the no form of this
command to disable route caching and return to process switching mode.
Note
Using Network Address Translation (NAT) or the SROS firewall capabilities on an
interface requires process switching mode (using the no ip route-cache command).
Syntax Description
No subcommands.
Default Values
By default, route caching is enabled on all interfaces.
Functional Notes
Route caching allows an IP interface to provide optimum performance when processing IP traffic.
Usage Examples
The following example enables route caching on a Frame Relay sub-interface:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#ip route-cache
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
954