HP ProCurve 7102dl Reference Manual page 774

SROS Command Line Interface Reference Guide
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface>
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Functional Notes
If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address
taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the ATM
Sub-Interface Configuration mode configures the ATM sub-interface to use the IP address assigned to the
Ethernet interface for all IP processing. In addition, the SROS uses the specified interface information
when sending route updates over the unnumbered interface.
Usage Examples
The following example configures the ATM sub-interface 1.1 to use the IP address assigned to the
Ethernet interface (eth 0/1):
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip unnumbered eth 0/1
5991-2114
Specifies the interface (in the format type slot/port) that contains the IP address
to use as the source address for all packets transmitted on this interface.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
772