HP ProCurve 7102dl Reference Manual page 462

SROS Command Line Interface Reference Guide
ip urlfilter server <ip address>
Use the ip urlfilter server command to identify a URL filter server by IP address and port number. Use
the no form of this command to remove the server from use. Variations of this command include:
ip urlfilter server <ip address>
ip urlfilter server <ip address> port <number>
ip urlfilter server <ip address> timeout <value>
Syntax Description
<ip address>
port <number>
timeout <value>
Default Values
By default, there are no URL filtering servers configured. When configuring a URL filtering server, the port
default is 15,868, and the timeout default is 5 seconds.
Usage Example
The following example identifies a URL filtering server at IP address 10.1.1.1 that listens for URL filtering
requests on port 15,868 (default) and waits for a response for 10 seconds before determining that the
filtering server is down:
ProCurve(config)#ip urlfilter server 10.1.1.1 timeout 10
5991-2114
Specifies the server IP address. IP addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1).
Specifies the server TCP port number which will receive requests.
Specifies the number of seconds to wait for a response from the URL
filtering server before determining that it is out of service. Range is 1 to
300 seconds.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
460