HP ProCurve 7102dl Reference Manual page 482

SROS Command Line Interface Reference Guide
mac address-table aging-time <aging time>
Use the mac address-table aging-time command to set the length of time dynamic MAC addresses
remain in the switch or bridge forwarding table. Use the no form of this command to reset this length to its
default.
Syntax Description
<aging time>
Default Values
By default, the aging time is 300 seconds.
Usage Examples
The following example sets the aging time to 10 minutes:
ProCurve(config)#mac address-table aging-time 600
5991-2114
Specifies an aging time (in seconds) from 10 to 1,000,000. Set to 0 to disable the
timeout.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
480