SROS Command Line Interface Reference Guide
Serial Interface Configuration Command Set
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface. Use the no form of this command to disable SNMP on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Usage Examples
The following example enables SNMP on the serial interface:
ProCurve(config)#interface serial 1/1
ProCurve(config-ser 1/1)#snmp trap
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
692