HP ProCurve 7102dl Reference Manual page 652

SROS Command Line Interface Reference Guide
ip pim-sparse override-interval <time>
Use the ip pim-sparse override-interval command to specify the delay interval after a join/prune in
which another router on the LAN may override the join/prune. Use the no form of this command to return
to the default value.
Syntax Description
<time>
Default Values
By default, the override-interval is set to 2500 milliseconds.
Usage Examples
The following example sets the delay interval for join/prune overrides to 3000 milliseconds on the eth 0/1
interface:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#ip pim-sparse override-interval 3000
5991-2114
Specifies the delay interval (in milliseconds) after a join/prune in which
another router on the LAN may override the join/prune. Valid range is 0 to
65,535 milliseconds.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
650