HP ProCurve 7102dl Reference Manual page 729

SROS Command Line Interface Reference Guide
backup connect-timeout <seconds>
Use the backup connect-timeout command to specify the number of seconds to wait for a connection
after a call is attempted before trying to call again or dialing a different number. It is recommended this
number be greater than 60.
Syntax Description
<seconds>
Default Values
By default, the backup connect-timeout period is set to 60 seconds.
Usage Examples
The following configures the SROS to wait 120 seconds before retrying a failed backup call:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#backup connect-timeout 120
5991-2114
Selects the amount of time in seconds that the router will wait for a connection
before attempting another call (valid range: 10 to 300).
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
727