HP ProCurve 7102dl Reference Manual page 81

SROS Command Line Interface Reference Guide
copy xmodem <destination>
Use the copy xmodem command to copy a file (using the XMODEM protocol) to a specified destination.
XMODEM capability is provided in terminal emulation software such as HyperTerminal™.
Syntax Description
<destination>
Destination filename:
Default Values
No default value necessary for this command.
Usage Examples
The following example copies a software file (J03_01.biz) to flash memory and labels it SROS.BIZ:
ProCurve#copy xmodem flash
Destination filename SROS.BIZ
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
The SROS is now ready to accept the file on the CONSOLE port (using the XMODEM protocol). The next
step in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Send File and browse to the file you wish to copy
(J03_01.biz). Once the transfer is complete, information similar to the following is displayed:
Received 531424 bytes.
Transfer complete.
5991-2114
Specifies the destination of the copied file.
Valid destinations include: cflash (installed compact flash card), flash (flash
memory), startup-config (the configuration file stored in flash memory), or
running-config (the current running configuration file).
After entering copy xmodem and specifying a destination, the SROS prompts for
the following information:
Specifies the filename to use when storing the copied file to flash memory. (Valid
only for the copy cflash and copy flash commands.)
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
79