HP ProCurve 7102dl Reference Manual page 242

SROS Command Line Interface Reference Guide
show ip traffic [realtime]
Use the show ip traffic command to display all IP traffic statistics. Variations of this command include:
show ip traffic
show ip traffic netstat
show ip traffic realtime
Syntax Description
netstat
realtime
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the terminal length command; refer to
Usage Examples
The following is a sample output from the show ip traffic command:
ProCurve>enable
ProCurve#show ip traffic
IP statistics:
Routing discards: 0
Rcvd: 15873 total, 7617 delivered
0 header errors, 0 address errors
0 unknown protocol, 0 discards
0 checksum errors, 0 bad hop counts
Sent: 8281 generated, 4459 forwarded
0 no routes, 0 discards
Frags: 0 reassemble required, 0 reassembled, 0 couldn't reassemble
0 created, 0 fragmented, 0 couldn't fragment
UDP statistics:
Rcvd: 3822 total, 0 checksum errors, 0 no port
5991-2114
Optional. Displays the network statistics for TCP sessions on the network.
Optional. Displays full-screen output in real-time. See the Functional Notes below
for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
terminal length <lines> on page 294).
240