HP ProCurve 7102dl Reference Manual page 241

SROS Command Line Interface Reference Guide
Usage Examples
The following is a sample output from the show ip route command:
ProCurve>enable
ProCurve#show ip route rip
Codes: C - connected S - static R - RIP O - OSPF IA - OSPF inter area
N1 - OSPF NSSA external type 1 N2 - OSPF NSSA external type 2
E1 - OSPF external type 1 E2 - OSPF external type 2
Gateway of last resort is 10.15.227.29 to network 0.0.0.0
R 10.15.223.0/30 [120/1] via 10.15.227.41, ppp 3
R 10.15.223.2/32 [120/1] via 10.15.227.41, ppp 3
R 10.15.226.0/28 [120/1] via 10.15.227.41, ppp 3
R 10.15.226.16/28 [120/1] via 10.15.227.41, ppp 3
R 10.15.226.48/28 [120/1] via 10.15.227.29, ppp 1
R 10.15.226.96/28 [120/1] via 10.15.227.29, ppp 1
The following example shows how to display IP routes learned via BGP. The values in brackets after a
BGP route entry represent the entry's administrative distance and metric:
ProCurve>enable
ProCurve#show ip route bgp
Codes: C - connected, S - static, R - RIP, O - OSPF, B - BGP
IA - OSPF inter area, N1 - OSPF NSSA external type 1
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1
E2 - OSPF external type 2
Gateway of last resort is 10.15.43.17 to network 0.0.0.0
B 1.0.0.0/8 [30/0] via 10.15.43.17, fr 1.17
B 2.0.0.0/9 [30/0] via 10.15.43.17, fr 1.17
B 2.128.0.0/10 [30/0] via 10.15.43.17, fr 1.17
B 2.192.0.0/11 [30/0] via 10.15.43.17, fr 1.17
B 2.224.0.0/12 [30/0] via 10.15.43.17, fr 1.17
B 2.240.0.0/13 [30/0] via 10.15.43.17, fr 1.17
B 2.248.0.0/14 [30/0] via 10.15.43.17, fr 1.17
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
239