SROS Command Line Interface Reference Guide
flowcontrol [none | software in]
Use the flowcontrol command to set flow control for the line console. Use the no form of this command to
return to the default setting.
Syntax Description
none
software in
Default Values
By default, flow control is set to none.
Usage Examples
The following example configures no flow control for the line console:
ProCurve(config)#line console 0
ProCurve(config-con 0)#flowcontrol none
5991-2114
Specifies no flow control.
Configures the SROS to derive flow control from the attached device.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Line (Console) Interface Config Command Set
541