HP ProCurve 7102dl Reference Manual page 483

SROS Command Line Interface Reference Guide
mac address-table static <mac address> bridge <bridge id> interface
<interface>
Use the mac address-table static command to insert a static MAC address entry into the MAC address
table. Use the no form of this command to remove an entry from the table.
Syntax Description
<mac address>
bridge <bridge id>
interface <interface>
Default Values
By default, there are no static entries configured.
Usage Examples
The following example adds a static MAC address to Ethernet 0/1 on bridge group 4:
ProCurve(config)#mac address-table static 00:12:79:00:00:01 bridge 4 interface ethernet 0/1
5991-2114
Specifies a valid 48-bit MAC address.
Specifies a valid bridge interface ID.
Specifies a valid slot/port interface ID. Type mac address-table static
bridge interface ? for a complete list of valid interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
481