Line (Ssh) Interface Config Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
L (SSH) I
INE NTERFACE
To activate the Line Secure Shell (SSH) Interface Configuration mode, enter the line ssh command
specifying a SSH session(s) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#line ssh 0 4
ProCurve(config-ssh0-4)#
You can select a single line by entering the line ssh command followed by the line number (0-4). For
example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#line ssh 2
ProCurve(config-ssh2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in
accounting commands
authorization commands
line-timeout <minutes>
login authentication <aaa login list>
login local-userlist
5991-2114
C
ONFIG
on page 562
on page 563
on page 566
on page 567
on page 568
on page 569
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Line (SSH) Interface Config Command Set

C S
OMMAND ET
on page 1431
561