SROS Command Line Interface Reference Guide
show frame-relay
Use the show frame-relay command to display configuration and status parameters for configured virtual
Frame Relay interfaces. Variations of this command include the following:
show frame-relay lmi
show frame-relay pvc
show frame-relay pvc interface frame-relay <interface>
show frame-relay pvc interface frame-relay <interface> realtime
show frame-relay pvc realtime
Syntax Description
lmi
pvc
interface
frame-relay
<interface>
realtime
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the #terminal length command).
5991-2114
Displays Link Management Interface (LMI) statistics for each virtual Frame Relay
interface.
Displays Permanent Virtual Circuit (PVC) configuration and statistics for all virtual
Frame Relay interfaces (or a specified interface).
Displays configuration and statistics for a specified Frame Relay interface.
Optional. Displays Frame Relay PVC statistics for a specific Frame Relay
interface.
Specifies the virtual Frame Relay interface (for example fr 1).
Displays full-screen output in realtime. See the Functional Notes section below for
more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
186